make a donation to the fz1oa
fz1oa chat
fz1oa picture uploader
maintain your own photo albums
locate fz1oa members
search the entire board
click here for fz1oa web site home page
register a new account, it's free!
email the fz1oa webmasters
read the fz1oa guidelines
read the fz1oa policy
open pat's fz1 site in a new window
open iowaz fz1 site in a new window
technical tips

Go Back   FZ1OA Message Board > FZ1 & Fazer Owners Association > Tires, Brakes, Suspension & Steering > Gen 1 Tires, Brakes, Suspension & Steering

Reply
 
Thread Tools Display Modes
Old 05-22-2019, 02:25 PM   #41
AndyW
Dumbass with a full PM inbox..
 
AndyW's Avatar
 
Join Date: May 2010
Location: Marietta, GA
Posts: 23,852
Regular grocery stores sell it as well - at least, here in GA.
__________________
'01 FZ1 set up for distance
'07 FZ1 set up for fun
(both in the *faster* blue)


Which would you prefer?
AndyW is offline   Reply With Quote
Old 05-27-2019, 12:55 PM   #42
firefly
2004 FZ1
 
firefly's Avatar
 
Join Date: Mar 2012
Location: Blind spot, CA
Posts: 870
I finished replacing the steering bearings, I was able to remove the lower race in less than 5 min, the upper took a little longer, I used a 9 inch punch I got from HF, pressed in the new allballs races, the upper race is much higher than the stock race and is flush with the frame's steering head? I was able to seat the lower race using the old race.

removing the lower bearing race from the triple was tough but I used the dremel to make a horizontal groove to give the chisel a good grip without marring the lower triple, stuffed some dry ice in the steering tube and used a hammer & chisel, finally it came off.

I pressed the lower bearing by using the race I removed together with a pipe & hammer it in.
I didn't use the upper allballs dust seal & used the stock part, using both didn't look right, I used the lower seal that came with the kit but forgot to use the stock dust seal which I think seals the lower steering stem better.

I'll go for a test ride, I expect to re torque the spanner nuts after a few miles when everything settles in place.

Test rode the bike, all is good & tight, very happy I finally did that service.

Thanks for all the help

Last edited by firefly; 05-27-2019 at 03:58 PM.
firefly is offline   Reply With Quote
Reply

Go Back   FZ1OA Message Board > FZ1 & Fazer Owners Association > Tires, Brakes, Suspension & Steering > Gen 1 Tires, Brakes, Suspension & Steering


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -7. The time now is 12:36 AM.


Questions? Comments?
Click on name below to contact via PM
Rabeet (Admin) Desmo (Admin)

Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Website and Message Board Contents Copyright 2001-2007 FZ1OA
The marks YAMAHA® and FZ1® are used under license from Yamaha Motor Corporation, U.S.A.
The information on this web site is NOT approved or endorsed by Yamaha Motor Corporation in any way.
Page generated in 0.05827 seconds with 10 queries